If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Biostar M7NCG 400 MoBo wAMD3300_any Ngroup for help
Bud in FL wrote:
Is there a NG for this Moboard? Purchased TIGER's BareBone special last week. I'm up & running but have a few questions not answered in the very slim-manual or nothing in FAQ on their home site. I saw the solution, I think, while looking at the multiple reviews for this board, but now I can't find that site with the 250+ reviews. It has to do with the 400 FSB settings in the BIOS [maybe?] at half rate in order for Could be one of those INTEL by design trap. I recently built a system from Tiger Direct. It was the Athlon64 3000. I installed 512mB of ddr 400 before reading the manual. It was a successfull build but the instructions for memory upgrades for my motherboard stated a total of 3GB can be installed but.......The first chip has be double-sided and others have to be single sided if you want to remain at ddr 400 or it will fall back to ddr300. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Anybody use a biostar mobo? Where can I find reviews? | Go Tyler | General | 3 | December 18th 05 08:13 PM |
Anybody use a biostar mobo? Where can I find reviews? | Go Tyler | Homebuilt PC's | 1 | December 18th 05 03:26 PM |
Sempron 3000+ on a Biostar nforce 2 Mobo? | Patrick Beaugrand | Overclocking AMD Processors | 2 | September 15th 05 10:21 AM |
Biostar M7VIZ mobo OK or junk? | larry moe 'n curly | Homebuilt PC's | 9 | July 17th 05 03:26 PM |
Bad Biostar MOBO experience | ROEKing | Overclocking AMD Processors | 0 | March 16th 05 11:41 PM |