If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Board doesn't recognize SATA drive
I'm a complete newbie to SATA, so I don't know if there's a problem
with my drive, motherboard or the way I'm setting it up. I'm trying to install my Maxtor Diamondmax 10 (100gb) drive with an Asus P4P800se (Intel chipset) motherboard. The bios doesn't see the drive unless I set it up under IDE configuration "Confiigure S-ATA as RAID" as "Yes". I can't just leave it as "Enhanced Mode Support On - SATA" or it doesn't find the drive. I don't want to run a RAID configuration as I plan to add a larger SATA drive in the future. How do you setup SATA? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Getting a single SATA drive to act as boot device on A7V600-X board | Phil Thompson | Asus Motherboards | 15 | June 14th 04 02:18 PM |
Network File Server | Bob | Storage (alternative) | 37 | May 4th 04 09:07 PM |
Need *HELP* retrieving data off failed hard drive - sources of info greatly appreciated | Stellijer | Storage (alternative) | 36 | December 19th 03 07:53 PM |
Hitachi 7K250 any good? | Jerry | Storage (alternative) | 20 | December 19th 03 12:47 AM |
FDISK, HDD #s, don't know how to install two HDDs. | sunslight | Storage (alternative) | 14 | October 29th 03 07:56 PM |