If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Cannot eject tape from PV 120T DLT1 Autoloader drive
How do I manually eject a DLT IV tape in a PV 120T DL1
autoloader drive? The autoloader makes a series of loud noises when I select the EJECT DRIVE mode on the control panel. The tape comes out about half an inch of the way no more. The autloader enters an alarm state. IF I powercycle and reissue the eject command the autoloader now says the source drive is empty even though the tape is still in there albeit partially out. The unit is currently detached from the SCSI connector. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Making a pure IDE/ATAPI tape drive work in a USB drive enclosure. (0/1) | Bloke at the pennine puddle (Replace n.a.v.d with | General | 0 | October 11th 03 05:02 PM |
cutting psu wires | Pen | General | 4 | July 27th 03 07:49 PM |