If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
CMOS setting reset itself after cold boot
This P4/Asus P4P800 DELUXE system works fine for a while. It's my
secondary system so I don't use it often. Lately it has the following message when booting cold: CMOS setting wrong CMOS Date/Time nto set New CPU installed. Please enter setup to configure your system. Press F1 to run setup. Press F2 to load default values and continue. The date would become January 1 2002. I have to set the time. After reboot, it remembers the setting and the message does not show up. If I turn it off for a while, then it always reset itself. What is the cause of this problem? How can I fix it? Thanks for the information. liu |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Reset CMOS | Pietro Gallo | Packard Bell Computers | 6 | November 19th 06 11:01 PM |
Easy Note VX - CMOS Reset | Ytzen Westra | Packard Bell Computers | 2 | March 4th 05 09:30 AM |
how to test psu and reset to cmos to default | Tanya | General | 23 | February 7th 05 09:56 AM |
i have to remove my CMOS battery to cold-boot! | mike | Gigabyte Motherboards | 2 | May 22nd 04 02:31 AM |
TUSL2 CMOS reset? | Paul | Asus Motherboards | 1 | July 8th 03 12:38 PM |