If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Failure of monitor to wake-up when PC does.
Dear all,
Your assistance is required once again... When I tried to 'wake up' my PC last night (Compaq Presario 5000 with MV540 monitor), the PC burst into life, but the monitor remained on stand-by. after switching both PC and monitor on and off repeatedly (I can ususally hear a relay clicking away when normal wake-up is achieved), I disconnected the monitor and powered it. It displayed the usual RGB 'check-cable' indication, so I took the monitor to be working OK. I eventually got the monitor working by removing the video card (NVIDIA GeForce) and re-fitting it. Everything then powered normally. Is it likely to be a video card fault, or a motherboard fault? Any suggestions appreciated! -- Kind Regds, Russell W. B. http://www.huttonrow.co.uk |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Asus P4C800E-Dlx - Wake on lan - HOW? | Noozer | Asus Motherboards | 3 | September 21st 04 08:10 AM |
Why mechanical failure causes HDD being undetectable by bios or OS ? | andy | General | 32 | September 8th 04 09:01 PM |
Why mechanical failure causes HDD being undetectable by bios or OS ? | andy | General | 0 | September 3rd 04 04:02 AM |
P4P800 acting flakey bios checksum failure | Stacey | General | 6 | March 7th 04 04:35 PM |
P4P800 Deluxe Wake on Lan problem | Pedge | Asus Motherboards | 0 | January 5th 04 02:26 AM |