If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
4mp fuser replacement help
Anybody remember how to get the fuser out of a 4 mp. Someone suggested it
came out the back door of the printer, and there IS a green pushbutton flange in there...but pushing it does nothing to let the fuser move. If that isn't correct, how do I get the case off the damn printer itself? Thanks |
#2
|
|||
|
|||
If I remember correct, the fuser is held in place by two screws on the
bottom plate. You should see them if you open the rear door. Jeff "Curmudgeon" schreef in bericht .. . Anybody remember how to get the fuser out of a 4 mp. Someone suggested it came out the back door of the printer, and there IS a green pushbutton flange in there...but pushing it does nothing to let the fuser move. If that isn't correct, how do I get the case off the damn printer itself? Thanks |
#3
|
|||
|
|||
On Fri, 9 Jul 2004 17:07:47 +0200, "FutureChild"
future|dot|child|at|wanadoo|dot|nl wrote: If I remember correct, the fuser is held in place by two screws on the bottom plate. You should see them if you open the rear door. Jeff "Curmudgeon" schreef in bericht . .. Anybody remember how to get the fuser out of a 4 mp. Someone suggested it came out the back door of the printer, and there IS a green pushbutton flange in there...but pushing it does nothing to let the fuser move. If that isn't correct, how do I get the case off the damn printer itself? Thanks Jeff; I had a system crash, contact me via email at Paul |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
QMS Magicolor 2 - Fuser Replacement or repair | Jessica | Printers | 6 | April 6th 04 03:07 PM |
Pantone replacement cartridges! | Brendan R. Wehrung | Printers | 0 | November 24th 03 07:32 AM |
Minolta CF911 Repair and Fuser Oil | Jcoman | Printers | 8 | October 9th 03 05:54 PM |
Minolta CF911 Repair and Fuser Oil | Jcoman | Printers | 0 | October 7th 03 09:17 PM |
Fuser too cold | santa | General | 3 | July 9th 03 10:13 AM |