A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » Processors » Overclocking AMD Processors
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

A8V DeLuxe (4800+ @ PR5009)



 
 
Thread Tools Display Modes
  #1  
Old March 17th 07, 02:56 PM posted to alt.comp.hardware.overclocking.amd
M.A.Rauder
external usenet poster
 
Posts: 3
Default A8V DeLuxe (4800+ @ PR5009)

A8V DeLuxe Bios Settings (AMD4800+)
SiSoft Sandra Processor Performance Rating: PR5009 (estimated)

Advanced
----------
Hypertransport 1000
- HT Data 16
- HT Data 16

Memory Configuration
-----------------------
Memlock Limit
Memlock to CPU 5:3 (333)
Hw Memory hole disabled
Burst Lenght 8 beats
- All the Rest auto

ECC disabled
Cool & Quiet enabled

PCI/PnP Settings
-----------------
Plug and Play O/S Yes
PCI Latency timer 64

Config System Frequency/Voltage
----------------------------------
AI Overclocking Manual
CPU FSB Frequency 232 MHz
AGP/PCI Frequency 66,66/33,33
DDR Voltage 2,7
AGP Voltage 1,5
V-Link Voltage 2,5

Power-Hardware Monitor
- CPU Q-Fan enabled 11/16
- Chassis Q-Fan enabled 11/16

I use bios 1018.001
I run on this board w 4800x2 and XP pro.
When I put 4x1GB in the slots, i can't post
because of this warning:
"USB Device over current status Detected!
System will shutdown over 15 seconds"
And indeed it schuts off, so I can't go in the
bios to alter the settings with this ram amount.

When I put 2x1024 in 1 and 3, and 2x512 in
2 and 4, then I got 3GB of ram, and it works
normally tested with DDR400@3-3-3-8 CR2

(10-1 pin FP_AUDIO)
Don't forget to have the 2 jumpers on the
audioconnector on the mainboard if you
don't use a frontpanel audio connection.
This can be a source of instability.

Overclocking or not, this learns a lot (Dutch):
http://gathering.tweakers.net/forum/...ssages/1050603

If you get blue screens with:
"Driver IRQL not Less or Equal" then there is a patch
http://support.microsoft.com/kb/929338



  #2  
Old March 18th 07, 09:38 AM posted to alt.comp.hardware.overclocking.amd
Paul
external usenet poster
 
Posts: 13,364
Default A8V DeLuxe (4800+ @ PR5009)

M.A.Rauder wrote:
A8V DeLuxe Bios Settings (AMD4800+)
SiSoft Sandra Processor Performance Rating: PR5009 (estimated)

Advanced
----------
Hypertransport 1000
- HT Data 16
- HT Data 16

Memory Configuration
-----------------------
Memlock Limit
Memlock to CPU 5:3 (333)
Hw Memory hole disabled
Burst Lenght 8 beats
- All the Rest auto

ECC disabled
Cool & Quiet enabled

PCI/PnP Settings
-----------------
Plug and Play O/S Yes
PCI Latency timer 64

Config System Frequency/Voltage
----------------------------------
AI Overclocking Manual
CPU FSB Frequency 232 MHz
AGP/PCI Frequency 66,66/33,33
DDR Voltage 2,7
AGP Voltage 1,5
V-Link Voltage 2,5

Power-Hardware Monitor
- CPU Q-Fan enabled 11/16
- Chassis Q-Fan enabled 11/16

I use bios 1018.001
I run on this board w 4800x2 and XP pro.
When I put 4x1GB in the slots, i can't post
because of this warning:
"USB Device over current status Detected!
System will shutdown over 15 seconds"
And indeed it schuts off, so I can't go in the
bios to alter the settings with this ram amount.

When I put 2x1024 in 1 and 3, and 2x512 in
2 and 4, then I got 3GB of ram, and it works
normally tested with DDR400@3-3-3-8 CR2

(10-1 pin FP_AUDIO)
Don't forget to have the 2 jumpers on the
audioconnector on the mainboard if you
don't use a frontpanel audio connection.
This can be a source of instability.

Overclocking or not, this learns a lot (Dutch):
http://gathering.tweakers.net/forum/...ssages/1050603

If you get blue screens with:
"Driver IRQL not Less or Equal" then there is a patch
http://support.microsoft.com/kb/929338


To fix the "USB Device over current" problem, use an earlier
BIOS if possible. And report the problem to Asus. You do not
need to tell them what OS you are using, and the fewer unnecessary
details, the more likely they will take the report seriously.
At the very least, do not use the word "Vista" anywhere in
your report to Asus Tech Support.

http://vip.asus.com/forum/view.aspx?...Language=en-us

Paul
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
x2 4800 vs Fx60 Haggar Overclocking AMD Processors 1 February 21st 07 05:56 PM
Temperature reading accuracy? (4800 & A8N32-SLI Deluxe) [email protected] Asus Motherboards 2 December 26th 05 02:40 PM
FX-55 vs. X2 4800+ formerprof Asus Motherboards 4 November 7th 05 04:29 PM
asus A8V deluxe and AMD 4800+ dual core X2 Lynn McGuire Asus Motherboards 7 July 21st 05 04:30 PM
Best drivers for GF 4800 Ti / XP JonMaC Nvidia Videocards 6 September 10th 04 08:47 AM


All times are GMT +1. The time now is 09:33 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.