If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Netfinity 5100 SCSI Backplane schematics
Has any of you ever seen one, or know who at IBM to ask for one?
I have salvaged one from a server with a dead motherboard, and so far I'm able to run all 6 slots in a standard PC, the SCSI ID's however are different from the ones normally available in operation on a standard NF5100. I would like to figure out how the backplane assigns ID's for the slots. The FRU is #00N9557. |
#2
|
|||
|
|||
Netfinity 5100 SCSI Backplane schematics
Lars Randers wrote in k
Has any of you ever seen one, or know who at IBM to ask for one? I have salvaged one from a server with a dead motherboard, and so far I'm able to run all 6 slots in a standard PC, the SCSI ID's however are different from the ones normally available in operation on a standard NF5100. So you already know how it assigns them. I would like to figure out how the backplane assigns ID's for the slots. Is there anything holding you back and do exactly that? The FRU is #00N9557. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Proliant ML530 6 x Scsi backplane Power connector Pin assignment | Yeti68 | Compaq Computers | 0 | March 5th 06 12:43 AM |
RFC: Gateway 840 external SCSI-to-SATA backplane | Dan Adams | Storage (alternative) | 0 | June 19th 05 03:21 PM |
Installing ScSi CD to deskpro XL 5100 | Bevin B. | Compaq Computers | 1 | November 7th 04 01:43 AM |
Netfinity EXP 300 | arzulu | Storage (alternative) | 1 | October 12th 04 07:01 PM |