If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#38
|
|||
|
|||
"BIOS problem" solved
On 06/11/2014 09:22, Rod Speed wrote:
J. P. Gilliver (John) wrote Rod Speed wrote I've never had a problem with my samsungs. Sounds painful! Nope, completely painless. Any of the small molecular weight alcohols are fine. The SATA cable should not be bent until it kinks. That's true of any signal cable like that. This has an impact on the dielectric insulation inside the cable. And can change the cable impedance. Cable impedance just isnt a problem with digital signals. If it wasn't, you wouldn't be worrying about kinks above. I don't worry about kinks above. It's an analogue world Nope. - especially at the sort of frequencies we work at these days. Not in the sense that the cable impedance matters. But even back in the days of 10 megabit ethernet, impedance was relevant (75 ohm coax, IIRR). That's why, ideally, you had terminators. But PATA didn't and SATA doesn't either. I'm sure SATA does have terminators, it's just that they're built in to the devices at the ends of the cable, and there are no devices connected anywhere in the middle of the cable. My understanding is that PATA does too but that they're not terminated very precisely, so that whether you have one drive or two it still works "well enough". -- Brian Gregory (in the UK). To email me please remove all the letter vee from my email address. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
USB bootable maker: Diff between "HP Drive Key Boot Utility" and "HP USB Disk Storage Format Tool"? | Jason Stacy | Storage (alternative) | 1 | April 21st 09 01:14 AM |
"true life" vs. "anti-glare" of Vostro 1500: What are the brightness & contrast ratios??? | Thomas G. Marshall | Dell Computers | 1 | April 11th 08 10:47 PM |
HP 6980 - won't properly connect "securely" via wireless - only "unsecurely" | [email protected] | General | 1 | September 13th 07 07:35 PM |
Solved: Nero CD Copy error "path is invalid" | FUBARinSFO | Cdr | 0 | September 13th 07 03:07 AM |
Downside of changing "Max frames to render ahead"/"Prerender Limit" to 1/0? | Jeremy Reaban | Nvidia Videocards | 2 | March 31st 06 04:24 AM |