If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Applying TX-4?
Any trick to applying this? I bought a syringe of TX-4 paste to use in
my new system but can't apply it. I rolls up, rolls of the CPU, sticks to the spreader and does just about anything but stick to the CPU. It's VERY thick and hard to control. Anyone have any suggestions? |
#2
|
|||
|
|||
Applying TX-4?
Did you clean your cpu with 99% isopropyl alcohol and q-tips until you
can't see anything on the q-tips, then use a dry one to finish up? -- Ed Light Better World News TV Channel: http://realnews.com Iraq Veterans Against the War and Related: http://ivaw.org http://couragetoresist.org http://antiwar.com Send spam to the FTC at Thanks, robots. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Restart when applying SLI? | @sh[_2_] | Nvidia Videocards | 7 | November 2nd 07 10:16 PM |
Applying heatsink compound | Godzilla Pimp | Homebuilt PC's | 4 | March 9th 06 11:33 PM |
Applying A Variable Load to A CPU | GSV Three Minds in a Can | General | 4 | January 23rd 04 04:38 AM |
New Drivers 3.13 - Is Uninstall required before applying 3.13 | stanmc | Asus Motherboards | 6 | November 6th 03 09:06 PM |
applying thermal grease | Hawkeye | Asus Motherboards | 3 | August 2nd 03 08:14 PM |