If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Which KT333A boards 'unofficially' support 400fsb?
As subject: Which KT333A boards 'unofficially' support 400fsb?
I wanna get one when the prices drop after kt600 comes out. Thanks. -- http://www.it-is-truth.org/ |
#2
|
|||
|
|||
No KT333 (or KT400) board supports 400FSB the chip-set does not have the
divider necassary to keep the pci and agp bus in spec. You may be able to overclock to 400FSB but all your pci and agp divices will be running well out of spec and problems are likely. Why not jut but a Nforce 2 Ultra 400 board (e.g. NF7 V2.0) they are reasonably priced now. "Asfand Yar Qazi" wrote in message ... As subject: Which KT333A boards 'unofficially' support 400fsb? I wanna get one when the prices drop after kt600 comes out. Thanks. -- http://www.it-is-truth.org/ |
#3
|
|||
|
|||
BigBadger wrote:
No KT333 (or KT400) board supports 400FSB the chip-set does not have the divider necassary to keep the pci and agp bus in spec. You may be able to overclock to 400FSB but all your pci and agp divices will be running well out of spec and problems are likely. Why not jut but a Nforce 2 Ultra 400 board (e.g. NF7 V2.0) they are reasonably priced now. 1. Bad Linux support 2. Not as reasonably as I'd hoped :-) I'll stick with 333fsb methinks, thanks. -- http://www.it-is-truth.org/ |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ECS Pathetic Technical Support | Pedro Corbett | General | 14 | July 29th 04 03:53 AM |
Upgrade old PPGA MoBo w/ Lin-Lin 370 to FC-PGA or ... ? | pgtr | General | 3 | June 27th 04 03:29 AM |