If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
ALR Quad6: dead battery ?
Hi,
I bet there are some ALR Quad6 zealots in this newsgroup... Here's my problem: My Quad6 started to act up today. When it boots, it first displays CPU = Pentium ??? Mhz Then: EISA Configuration NVRAM Bad - Run setup ....then after the mem check (which completes OK) I get: SYSTEM BATTERY IS DEAD - REPLACE AND RUN SETUP Real Time Clock Error. So, where to begin? What could be wrong?. And most important: WHERE is the battery (if any) on the Quad6 mobo? I looked around and couldn't find anything resembling a battery. Thanks, Willy |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
computer won't power up - BIOS problem? | Yup | General | 16 | January 7th 05 05:41 AM |
M300 battery suddenly dead! | Raymond Shaw | Compaq Computers | 1 | October 8th 04 06:49 PM |
Presario 710 battery charger dead | Dillon Family | Compaq Computers | 1 | July 5th 04 02:02 PM |
how to get into setup after battery dead? | HH | Compaq Computers | 1 | June 25th 04 08:53 PM |
Battery dead? | Sheepeh | Compaq Computers | 0 | June 11th 04 01:27 PM |