If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Anomaly
Hello,
i've got bit of a problem with my Duron-Athlon XP. Can't get it to work with 200 fsb. Works ok at 2000/200 but breaks at any multiplier higher than that (tried 1.775V). On the other hand, if i lower the fsb to 166, it can be made stable at 2324, so higher frequencies are no problem. The RAM is also out of the question, because i was running the system 166:200 no prob. Chipset is nForce2 ultra, the board is Leadtek K7NCR18D pro which doesn't allow adjustments to the chipset voltage (in fact after a CMOS reset it does, but then it grays out the selection and it doesn't really seem to improve anything). |
Thread Tools | |
Display Modes | |
|
|