If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Arcserve v9 for Netware
I'm running a trial version of Arcserve v9.0 for Netware on a NW5.1 Sp6 box.
I'm trying to backup an HP ProLiant DL 360 server which has a Gigabit ethernet card installed in it. My Media server had a 100Mbps NIC which I swapped out and installed a Gigabit card into. However I am continually getting the same error which is: E15030 Failed to receive data/request from PUSKAS This error is totally consistent, the backup fails at the same point every time - approximately 16 mins into the job. Anyone got any ideas what's causing this ? Needless to say the CA website doesn't have anything on this error code ! cheers, Tony |
Thread Tools | |
Display Modes | |
|
|