If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
tape header ID
Hi,
I wanted to throw this out there. I am trying to identify what created some tapes I have. These are 1024 byte blocked. The first two blocks contain "IDH2" in the first four bytes of each block respectively. Then two (yes two) tape marks then data. Probably a netware server, early 90's (ish). Ring any bells? Thanks. 2H |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Com Port Setting Discrepancy? | Elle | General | 4 | February 25th 06 12:19 AM |
RAM problem | Alb | Asus Motherboards | 9 | January 31st 06 12:48 PM |
Travan tape drive draws tape completely off take-up reel | John B | General | 5 | June 15th 05 12:22 AM |
Fiber channel tape drive config help | Kyle Tucker | Storage & Hardrives | 8 | December 28th 04 04:08 AM |
AIT tape media lifetime? | Ralf Fassel | Storage & Hardrives | 2 | October 8th 04 11:05 AM |