If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Need help setting SAN boot to CLARiiON from Emulex LP9002
I pretty much followed the instructions from EMC/Emulex documentation:
1) updated to boot BIOS 2) enabled BIOS on HBA 3) create zone so the HBA has only one logical path to the SP 4) created a LUN on the same SP that the HBA has access to 5) disabled local RAID controller on the host 6) Hit ALT-E during POST to configure SAN boot. Select "Configure Boot Devices" then selected 1 from "List of Saved Boot Devices". It then listed the DID and WWPN of the CLARiiON that is available. It then prompted me to "Enter two digits of the starting LUN". I typed in 00 and and then it came back with a list of LUNs from LUN #00 to LUN #05 My question is how do I know which LUN is the one I created in step 4? Also, should I create a storage group from Navisphere and the LUN and host in the group between I start messing around with all this? Any help is appreciated. |
#2
|
|||
|
|||
Need help setting SAN boot to CLARiiON from Emulex LP9002
wrote in message ups.com... I pretty much followed the instructions from EMC/Emulex documentation: 1) updated to boot BIOS 2) enabled BIOS on HBA 3) create zone so the HBA has only one logical path to the SP 4) created a LUN on the same SP that the HBA has access to 5) disabled local RAID controller on the host 6) Hit ALT-E during POST to configure SAN boot. Select "Configure Boot Devices" then selected 1 from "List of Saved Boot Devices". It then listed the DID and WWPN of the CLARiiON that is available. It then prompted me to "Enter two digits of the starting LUN". I typed in 00 and and then it came back with a list of LUNs from LUN #00 to LUN #05 My question is how do I know which LUN is the one I created in step 4? Also, should I create a storage group from Navisphere and the LUN and host in the group between I start messing around with all this? Any help is appreciated. There's nothing else for you to do. You've created your target/lun map in the HBA BIOS and it will only attempt to boot from this device. Moojit |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Emulex Netjet | Harani | Printers | 2 | January 14th 07 02:37 AM |
Emulex LP-9002L-E | derek123 | Storage & Hardrives | 2 | September 1st 06 09:47 AM |
configuring linux on san with emulex (brocade/emc) | [email protected] | Storage & Hardrives | 1 | January 28th 05 05:35 PM |
Configuring Boot from SAN (Emulex/EMC/Win2K) | ohaya | Storage & Hardrives | 9 | September 26th 04 10:55 PM |
JNI or Emulex for 1G Fibre Channel HBA? | news.directlink.net | Storage & Hardrives | 4 | February 23rd 04 03:04 AM |