|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 10th 05, 10:02 PM
|
|||
|
|||
Scanner Button Will Not Work
1. Ensure scanner is on.
2. Go to Control Panel open Scanner and Cameras 3. Click on Devices tab, make sure your Scanner is highlighted, click on Properties 3. Go to Events tab under Start Button click on programs you want to start 4. To test Scanner go to General tab 5. Utility tab shows Interface used in connection to you Scanner 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Last/Fastest cB0 stepped 'gray zone' Celerons work natively on Abit ZM6/BM6? | pgtr | General | 15 | July 9th 04 07:29 PM |
| Scanner Problem Twain vs WIA | Don Burklo | Scanners | 1 | June 6th 04 11:53 AM |
| Scanner Problem Twain vs WIA | Don Burklo | Scanners | 5 | May 31st 04 01:48 PM |
| Acrobat Import from Scanner doesn't work | Jian | Scanners | 1 | December 8th 03 03:28 AM |
| Kodak PCD 4050 film scanner how to make tit work? | peter | Scanners | 2 | November 27th 03 07:38 AM |
Linear Mode
