If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
IPAQ, how to get into the case??
I just bought a IPAQ C800 from a surplus auction. How do I open the case??
I cannot find any latches. There is a plastic brace on the back held by two screws (torx with a pin in the middle) I don't have the right bit to get this brack off. Is this how the case disassembles? |
#2
|
|||
|
|||
to get the case off the ipaq you will need a torx t15 security bit,
you will be able to get this from any good hardware store. Once you have got this you will be able to remove the case. if you want more details just go to the hp website and look for the maintenance and service manual or look for Compaq iPAQ Family of Internet Devices -- Chapter 4 Removal and Replacement i hope that this helps Matthew Hilton |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Optimum temperature for P4 Prescott? | Bobby | General | 27 | November 19th 04 05:45 AM |
Upgrade Report [GeekTech: On the Case - 08/24/2004] | Ablang | General | 0 | August 26th 04 04:23 AM |
Happy Birthday America | SST | Ati Videocards | 336 | November 27th 03 08:54 PM |
Happy Birthday America | SST | Nvidia Videocards | 336 | November 27th 03 08:54 PM |
Cooling Questions | Peter Cavan | Homebuilt PC's | 35 | September 2nd 03 06:42 AM |