If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Laserjet 8000/8100 & feeder unit removal
Hi
Is there some simple procedure to remove whole paper feeder unit from HP LJ 8000/8100 ? IŽd like to refurbish or change rollers between pickups and registration. They are impossible to access without deassembly. Are errors 13.5 and 13.9 caused by feed problems before registration (Check right door message) or are they caused by delays on post-fusing rollers ? --- Janne j j j @ i k i . f i |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
pc problems after g card upgrade + sp2 | ben reed | Homebuilt PC's | 9 | November 30th 04 01:04 AM |
LITEON's dark secret? | No Longer a LiteOn Customer | Homebuilt PC's | 49 | April 15th 04 04:41 AM |
Lite-On's dark secret? | No Longer a LiteOn Customer | Cdr | 11 | January 25th 04 04:54 PM |