If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
"No bootable devices"
This is a googlebait post; perhaps my experience an be of value to someone
else. Dell laptops sometimes refuse to load OS start with the text: "Primary hard disk drive not found Fixed optical drive not found No bootable devices - strike F1 to retry reboot, F2 for setup utility" Some people [1] assert this as a hard drive failure. This is not necessarily true. IME, this error occurs especially after the hard drive has been removed, changed or if the machine has experienced some kind of shock, like being dropped. What can have happened is that the connector between the hard drive and the laptop has become unaligned. There exists a page of instructions for dealing with this, though I can't for the life of me find it now, but they condense as follows (hire yourself a guy to do this if you're not confident about it yourself!) 1. With the screen closed, remove the 'K' screws on the underside of the laptop, and the hard drive's screw on the right side of the laptop. 2. With the laptop the right way up, carefully open the screen and slowly lift up the keyboard at the right hand side. 3. With care, the keyboard can be laid face down over the left of the machine without stressing the connectors attached to it. The hard drive to the right is now exposed. It may be obvious that the disk drive's connector is not pushed in, or it may not. The best advice I've seen on the web is to ensure that it fits both the hard drive /and/ the motheboard as closely as possible, and so one should remove the hard drive from the bay, then bend the caddy around the connector back so when it goes in, it goes all the way. However, on one occasion this didn't work for me. It turned out that my connector could be pushed *too far* into the motherboard's slot: I used a flat screwdriver to create a little distance between the two, and only then did the error messages vanish, and the OS could boot. Cheers all, [1] http://groups.google.com/groups?selm...s02.tsnz. net -- Al [ aim: LGeezerAIM | jabber: | yahoo: LGeezer_YHO ] |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Announcement] FlashBoot - a tool to make USB Flash Disks bootable | PrimeExpert | Asus Motherboards | 6 | February 8th 05 12:40 AM |
[Announcement] FlashBoot - a tool to make USB Flash Disks bootable | PrimeExpert | Gigabyte Motherboards | 0 | February 6th 05 06:00 PM |
[Announcement] FlashBoot - a tool to make USB Flash Disks bootable | PrimeExpert | General | 0 | February 6th 05 05:58 PM |
pc problems after g card upgrade + sp2 | ben reed | Homebuilt PC's | 9 | November 30th 04 01:04 AM |
FPS Really LOW - Whats Wrong? | John W. | Ati Videocards | 5 | January 20th 04 08:09 AM |