If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Ninja Heatsink Review
Looks like a winner for overclocking quietly with a 120mm fan at low revs.
http://www.silentpcreview.com/article251-page1.html -- Ed Light Smiley :-/ MS Smiley :-\ Send spam to the FTC at Thanks, robots. |
#2
|
|||
|
|||
yeah and rip your motherboard out as well. Gee, that must put lots of
pressure on the board and cpu. "Ed Light" wrote in message news:QTGse.1343$eV4.870@fed1read01... Looks like a winner for overclocking quietly with a 120mm fan at low revs. http://www.silentpcreview.com/article251-page1.html -- Ed Light Smiley :-/ MS Smiley :-\ Send spam to the FTC at Thanks, robots. |
#3
|
|||
|
|||
"Frank" wrote in message ... yeah and rip your motherboard out as well. Gee, that must put lots of pressure on the board and cpu. Well, the article says "Modest mass and good weight distribution." -- Ed Light Smiley :-/ MS Smiley :-\ Send spam to the FTC at Thanks, robots. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Changing out stock heatsink on mobo for heatsink with fan | John Barrington | Asus Motherboards | 0 | October 11th 04 04:44 PM |
Processor Stuck to Heatsink via Thermal Pad | g00n | General Hardware | 5 | February 8th 04 06:27 AM |
Tomonobu Itagaki on Ninja Gaiden, Xbox2 and more! | R420 | Ati Videocards | 0 | December 6th 03 05:24 AM |
Faulty fans: dust or bearings? | S.Boardman | General | 37 | October 16th 03 10:34 AM |
Zalman ZM-50HP VGA Heatsink & P4P800 Deluxe | John Smith | Asus Motherboards | 5 | June 26th 03 12:50 AM |