|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 8th 04, 09:48 PM
|
|||
|
|||
hp890c setting defaults
I want to set the default on my printer so that I always comes up in draft
mode, unless I pick otherwise. rq 
|
|
#2
November 8th 04, 10:09 PM
|
|||
|
|||
|
[This followup was posted to comp.periphs.printers and a copy was sent
to the cited author.] In article NQRjd.151550$nl.80367@pd7tw3no, says... I want to set the default on my printer so that I always comes up in draft mode, unless I pick otherwise. For Win9x/Me, right-click the printer in Start/Settings/Printers and choose Properties. Any changes will usually become the defaults (some programs individually save and restore settings.) For NT/2K/XP, right-click the printer and choose Document Defaults (NT) or Printing Preferences (2K/XP). Make your changes there to make them defaults. -- If there is a no_junk in my address, please REMOVE it before replying! All junk mail senders will be prosecuted to the fullest extent of the law!! http://home.att.net/~andyross
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Support from asus? (a bit long) | Robert Megee | Asus Motherboards | 13 | January 16th 05 03:15 AM |
| Setting CPU Speed (Asus A7V133) | Necromancer | Asus Motherboards | 1 | June 17th 04 08:49 AM |
| scoll wheel setting on a 200 laptop | Don Walthers | Gateway Computers | 0 | January 7th 04 04:39 PM |
| screen saver vs turn off monitor setting for LCD monitor | dave | General | 4 | December 7th 03 08:23 PM |
| Question about CAS latency setting | Flugel45 | Homebuilt PC's | 1 | September 2nd 03 04:27 PM |
Linear Mode
