If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
ML370 with SmartArray 5300 - won't boot
We have a Compaq Proliant ML370 with the SmartArray 5300 - 5 drives fitted;
- first two logical drive C (Windows 2000 Server system drive) in Raid 1 configuration, - second three logical drive D in RAID 5 Yesterday we did a Windows Update and restarted the server. It never came back up. It displays the memory check, shows the processors, then displays 'no SCSI devices detected' and then 'No System disk or disk error' Help! This is the Exchange server for the whole company. Any clue to what might be the culprit? The SmartArray controller perhaps? If it's replaced, would the array configuration (and the data on those disks) be preserved? Any advice greatly appreciated! Regards Mark |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Essentials 700 very hard to get booted | BillB | Gateway Computers | 3 | September 9th 04 05:23 PM |
Upgrade Difficulties | Ron B | Gateway Computers | 0 | February 14th 04 03:26 AM |
GA-8KNXP, how to configure BIOS for SATA? | John Ward | Gigabyte Motherboards | 20 | October 6th 03 07:42 AM |
Hard drive that boots elsewhere refuses to boot in this machine | Simon O'Connor | General | 9 | July 22nd 03 06:34 AM |
Dual Boot, How? | Paul \(Erie\) | General | 1 | June 24th 03 04:36 PM |