|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 13th 14, 11:10 AM
posted to alt.comp.hardware.pc-homebuilt
|
|||
|
|||
Thanks Paul
Got to say I always enjoy reading Paul's replies to any question posted.
Always helpful, cites references, and never condescending no matter the question. His explanations go way past yes or no, and give a much better understanding of why things work as they do. Thank you for your contributions. It's the main reason I still follow the NG. Wish you had been around when I first started building boxes back in the 90's. Bet I could have troubleshot driver and hardware issues must faster and knew why I needed what I did much better. Keep up the great work. Mark 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ping Paul | Buffalo[_2_] | Asus Motherboards | 5 | November 1st 12 05:09 PM |
| A question for our resident genious ....Paul of course:) --- nothing further inside... thanks for your help/reply Paul! | [email protected] | Homebuilt PC's | 0 | April 23rd 11 08:41 PM |
| Paul | Motor T | General | 10 | June 8th 10 08:24 PM |
| O.T. : Thanks Paul | Robert Blass | Homebuilt PC's | 1 | March 2nd 08 01:17 AM |
| PING: paul | sdlomi2[_2_] | Asus Motherboards | 2 | October 3rd 07 11:22 AM |
Linear Mode
