|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
January 29th 07, 11:32 PM
posted to alt.comp.periphs.scanner
|
|||
|
|||
Scanned slides now switching to negatives
I'm using an Epson perfection 1660 photo scanner. It's been a long time
since I scanned slides. After setting it up correctly I have scanner a couple of hundred slides which is a long tedious job. The last batch of 4 slided which were scanner have come out looking like color negatives rather than positives. I haven't altered any settings. Why should this happen? -- Thanks in advance 
|
|
#2
January 30th 07, 12:36 AM
posted to alt.comp.periphs.scanner
|
|||
|
|||
|
Scanned slides now switching to negatives
"The Old Fart" " " wrote in message
... I'm using an Epson perfection 1660 photo scanner. It's been a long time since I scanned slides. After setting it up correctly I have scanner a couple of hundred slides which is a long tedious job. The last batch of 4 slided which were scanner have come out looking like color negatives rather than positives. I haven't altered any settings. Why should this happen? -- Thanks in advance Check the input source setting. Scan Slides as Color Positive Film and Negatives as Color Negative Film. -- CSM1 http://www.carlmcmillan.com --
|
|
#3
January 30th 07, 03:16 PM
posted to alt.comp.periphs.scanner
|
|||
|
|||
|
Scanned slides now switching to negatives
"The Old Fart" " " wrote in message ... I'm using an Epson perfection 1660 photo scanner. It's been a long time since I scanned slides. After setting it up correctly I have scanner a couple of hundred slides which is a long tedious job. The last batch of 4 slided which were scanner have come out looking like color negatives rather than positives. I haven't altered any settings. Why should this happen? -- Thanks in advance Hi. Check your input selection Neg / Positive. Quite a lot of scanners tend to revert to their default settings without any warnings. My Minolta 5400 tends to reset to 2700 Dpi instead of the 5400 I want, if I forget to select the "Saved" job, and an earlier Nikon used to revert to Positives. It is a bloody irritating habit, and they all seem to have it. Roy G
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Scanned slides don't match projected image | David Causier | Scanners | 6 | January 1st 05 07:15 AM |
| Newbie question: Scanner recommendations - I have inherited a couple of thousand negatives and photos from the 1920s to the 1970s which I want to scan and save to CD | awhiteford | Scanners | 7 | December 18th 04 02:46 AM |
| Nikon Coolscan 5000 ED | Norman & Nancy Perry | Scanners | 8 | February 9th 04 07:07 AM |
| ScanDual 3 slides vs. negatives | Kevin Miller | Scanners | 2 | November 21st 03 11:16 PM |
| Printing scanned negatives | Akvatoid | Printers | 0 | August 12th 03 04:55 PM |
Linear Mode
