|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
AudioGrabber not sensing silence between tracks
Hi! There! Apologies if I'm in the wrong group, if so maybe someone
can point me to a more suitable one.
I'm using Audiograbber v 1.83. and copying from an audio cassette tape
to the HD. Surprisingly given my limited computer skills the program
works fine, except it will not detect the lack of audio between tracks
and simply records them as one wave file one after the other.
The settings seem the obvious ones: - Auto split tracks, Track split
sensitivity maximum (and all points between 1 & 9) When in the manual
recording mode as expected the curser moves to the next track when the
stop button in the program is pressed and records when the record
button is pressed.
During the lack of audio between tracks there is no detectable sound
when listening close to the speaker and the volume meter indicates a
single bar the same as if the line input is disabled, so seems that an
extraneous signal is not the cause. All other inputs have been
disabled except the line in.
Am I correct in assuming that the prog should automatically move down
the track name list each time one track finishes and record the next
track as it does in manual mode?
Probably too long winded of me but better too much info than not
Thanks for your time. Using WinXP
|Thread||Thread Starter||Forum||Replies||Last Post|
|Erasing CDR tracks?||robby||Cdr||1||February 18th 06 07:07 PM|
|Pause Between Tracks||Subliminal Demise||Cdr||18||January 31st 04 09:37 AM|
|splitting LP tracks in Nero?||Wayne Fulton||Cdr||6||December 31st 03 10:03 AM|
|Splice-like gaps between tracks w/Roxio ECDC||Mr. Mike||Cdr||5||December 10th 03 12:15 PM|