If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Processor Upgrade
I am considering upgrading my motherboard and processor - from Athlon M4(Thunderbird) 1.1 to an AMD XP 2800 - but will I need to get a new case as well? I currently have a 300watt case, I would be grateful if someone could advise me. Colin Webb |
#2
|
|||
|
|||
Processor Upgrade
On Tue, 06 Jan 2004 21:04:57 +0000, CW wrote:
I am considering upgrading my motherboard and processor - from Athlon M4(Thunderbird) 1.1 to an AMD XP 2800 - but will I need to get a new case as well? I currently have a 300watt case, I would be grateful if someone could advise me. If you like your current case, just replace the PS, or you could just upgrade the cpu only and keep the rest of your system. -- Abit KT7-Raid (KT133) Tbred B core CPU @2400MHz (24x100FSB) http://mysite.verizon.net/res0exft/cpu.html |
#3
|
|||
|
|||
Processor Upgrade
"CW" wrote in message ... I am considering upgrading my motherboard and processor - from Athlon M4(Thunderbird) 1.1 to an AMD XP 2800 - but will I need to get a new case as well? I currently have a 300watt case, I would be grateful if someone could advise me. Colin Webb Colin, I just built a new 2800 system and used a Thermaltake V1000D case with an Antec 480 Watt PSU and haven't had a single problem. Good luck and let us know what happens. Servo |
#4
|
|||
|
|||
Processor Upgrade
Thanks for all the info from everyone, I have since discovered I need a PSU
rated at least at 431Watts. I think I shall just replace the PSU (along with the motherboard and CPU) although a couple of the leads from the case (not the PSU) to the motherboard look a bit daunting to re-attach to my new motherboard. Did consider not replacing the motherboard but cannot upgrade the CPU on it. Colin Webb "RJW" wrote in message ... "CW" wrote in message ... I am considering upgrading my motherboard and processor - from Athlon M4(Thunderbird) 1.1 to an AMD XP 2800 - but will I need to get a new case as well? I currently have a 300watt case, I would be grateful if someone could advise me. Colin Webb Colin, I just built a new 2800 system and used a Thermaltake V1000D case with an Antec 480 Watt PSU and haven't had a single problem. Good luck and let us know what happens. Servo |
#5
|
|||
|
|||
Processor Upgrade
On Wed, 07 Jan 2004 12:36:15 +0000, CW wrote:
Did consider not replacing the motherboard but cannot upgrade the CPU on it. Why? Who told you you couldn't? That's what abit told me too. Does it have at least a 50MHz FSB? If it does (and they didnt make any socket A boards any slower than 100MHz) it should be able to run any socket A cpu made. You just have to know how, and get the right one if you want it to be easy. What board and chipset do you board have? See link below. -- Abit KT7-Raid (KT133) Tbred B core CPU @2400MHz (24x100FSB) http://mysite.verizon.net/res0exft/cpu.html |
#6
|
|||
|
|||
Processor Upgrade
"CW" wrote in message
... Thanks for all the info from everyone, I have since discovered I need a PSU rated at least at 431Watts. I think I shall just replace the PSU (along with the motherboard and CPU) although a couple of the leads from the case (not the PSU) to the motherboard look a bit daunting to re-attach to my new motherboard. Did consider not replacing the motherboard but cannot upgrade the CPU on it. Colin Webb Any leads (speaker, power, reset, etc.) from the case to the existing mobo should be carefully documented BEFORE detaching them. Your new mobo will have instructions on where these leads connect. Check them carefully before powering up. |
#7
|
|||
|
|||
Processor Upgrade
On Wed, 07 Jan 2004 19:10:58 GMT
Wes Newell wrote: On Wed, 07 Jan 2004 12:36:15 +0000, CW wrote: Did consider not replacing the motherboard but cannot upgrade the CPU on it. Why? Who told you you couldn't? That's what abit told me too. Does it have at least a 50MHz FSB? If it does (and they didnt make any socket A boards any slower than 100MHz) it should be able to run any socket A cpu made. You just have to know how, and get the right one if you want it to be easy. What board and chipset do you board have? See link below. That's like saying "if you want to become a billionaire you just have to know how". The "knowing how" is the catch. I note that you're real big on "anything can be done" but not very strong on "here's how to do it" except for the one or two boards with which you have personal experience. -- Abit KT7-Raid (KT133) Tbred B core CPU @2400MHz (24x100FSB) http://mysite.verizon.net/res0exft/cpu.html -- -- --John Reply to jclarke at ae tee tee global dot net (was jclarke at eye bee em dot net) |
#8
|
|||
|
|||
Processor Upgrade
On Wed, 07 Jan 2004 16:13:08 -0500, J.Clarke wrote:
On Wed, 07 Jan 2004 19:10:58 GMT Wes Newell wrote: On Wed, 07 Jan 2004 12:36:15 +0000, CW wrote: Did consider not replacing the motherboard but cannot upgrade the CPU on it. Why? Who told you you couldn't? That's what abit told me too. Does it have at least a 50MHz FSB? If it does (and they didnt make any socket A boards any slower than 100MHz) it should be able to run any socket A cpu made. You just have to know how, and get the right one if you want it to be easy. What board and chipset do you board have? See link below. That's like saying "if you want to become a billionaire you just have to know how". The "knowing how" is the catch. I note that you're real big on "anything can be done" but not very strong on "here's how to do it" except for the one or two boards with which you have personal experience. WTF is your problem John. You've been ragging on me for a while now and I'm getting a little sick of it. And since I don't know which board he has, how the hell do you expect me to tell him how to do it. If you're so ****ing smart, you tell him. Also, the link below applies to most boards, not just the ONE I have. I've pointed this out to many with different types of boards from many different manufacturers and they have confirmed everything I've said. Yes, there's a few that have had problems, but this proves mostly, if not entirely, to be from the lack of understanding of the invidual. So unless you have a crystal ball and can tell this guy how to do it, why not just keep your ****ing insults to yourself. I was just pointing out that he has other options than to replace his board. -- Abit KT7-Raid (KT133) Tbred B core CPU @2400MHz (24x100FSB) http://mysite.verizon.net/res0exft/cpu.html |
#9
|
|||
|
|||
Processor Upgrade
On Wed, 07 Jan 2004 23:22:27 GMT
Wes Newell wrote: On Wed, 07 Jan 2004 16:13:08 -0500, J.Clarke wrote: On Wed, 07 Jan 2004 19:10:58 GMT Wes Newell wrote: On Wed, 07 Jan 2004 12:36:15 +0000, CW wrote: Did consider not replacing the motherboard but cannot upgrade the CPU on it. Why? Who told you you couldn't? That's what abit told me too. Does it have at least a 50MHz FSB? If it does (and they didnt make any socket A boards any slower than 100MHz) it should be able to run any socket A cpu made. You just have to know how, and get the right one if you want it to be easy. What board and chipset do you board have? See link below. That's like saying "if you want to become a billionaire you just have to know how". The "knowing how" is the catch. I note that you're real big on "anything can be done" but not very strong on "here's how to do it" except for the one or two boards with which you have personal experience. WTF is your problem John. My problem is that your little fantasy doesn't pass reality check--you keep asserting over and over that any socket A chip can be used in any Socket A board, and it simply ain't so. You may _believe_ it is, but that just means that you haven't encountered a board that won't allow it. You've been ragging on me for a while now and I'm getting a little sick of it. Pity. And since I don't know which board he has, how the hell do you expect me to tell him how to do it. I've never seen you tell _anybody_ how to do it. And if you don't know what motherboard he has, how do you know that it will work? If you're so ****ing smart, you tell him. You're the self-proclaimed expert here, not me. And since I've never claimed that you can stick any random Athlon into any random Socket A board and have it work, I fail to see why I would be expected to tell someone how to do this. Also, the link below applies to most boards, not just the ONE I have. The link mentions specifically the KT133. It doesn't say anything at all about any other chipset except the KT133A, and it doesn't mention any brand of board but Abit. While the techniques described very likely will work with many other boards and chipsets, that doesn't mean that they will work for every board and every chipset. I've pointed this out to many with different types of boards from many different manufacturers and they have confirmed everything I've said. So? "Many" is not "all" Yes, there's a few that have had problems, but this proves mostly, if not entirely, to be from the lack of understanding of the invidual. Uh huh. When you can't figure out how to make it work blame the other guy. So unless you have a crystal ball and can tell this guy how to do it, why not just keep your ****ing insults to yourself. I was just pointing out that he has other options than to replace his board. He has some things that he can try, with no guarantee that they'll work. -- Abit KT7-Raid (KT133) Tbred B core CPU @2400MHz (24x100FSB) http://mysite.verizon.net/res0exft/cpu.html -- -- --John Reply to jclarke at ae tee tee global dot net (was jclarke at eye bee em dot net) |
#10
|
|||
|
|||
Processor Upgrade
|
Thread Tools | |
Display Modes | |
|
|