If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Fujitsu MPG3204AT, 20GB drive will not POST, WHY?
I've been trying to get this drive to be recognized by my Biostar board. It
will hang the POST showing nothing when connected to the PRImary IDE controller as MASTER. If it's on the SECondary IDE the POST will progress fine, and the system goes on and identifies the drives... Any thoughts? Thanks Andrew |
#2
|
|||
|
|||
"Andrew" wrote in message
news I've been trying to get this drive to be recognized by my Biostar board. It will hang the POST showing nothing when connected to the PRImary IDE controller as MASTER. If it's on the SECondary IDE the POST will progress fine, and the system goes on and identifies the drives... Any thoughts? I'm surprised that your Fujitsu MPG is still working! Every single one that my company installed has now failed. These drives use a Cirrus Logic Arm chip that the maker encapsulated in a wrong type of epoxy resin. It becomes conductive over time shorting out the chip. There are law suites going on all over the world against Fujitsu because of it. http://www.classactioncounsel.com/fu...litigation.htm http://www.theregister.co.uk/content/archive/27926.html http://www.theregister.co.uk/content/archive/27871.html http://www.theregister.co.uk/content/archive/27112.html http://www.theregister.co.uk/content/archive/28384.html |
#3
|
|||
|
|||
The partition is not set active and/or the jumpers are incorrectly set.
Andrew wrote: I've been trying to get this drive to be recognized by my Biostar board. It will hang the POST showing nothing when connected to the PRImary IDE controller as MASTER. If it's on the SECondary IDE the POST will progress fine, and the system goes on and identifies the drives... Any thoughts? Thanks Andrew |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help! WinXP can't tell that my 2nd hard drive is already formatted | FitPhillyGuy | General | 12 | September 26th 03 03:38 AM |
Seagate Hard Drive - Faulty? | Mike Walker | General | 2 | September 5th 03 02:06 AM |
Hard drive invisible after long "power off" | Peter | General | 7 | July 25th 03 09:39 AM |
Need Fujitsu hard drive in Spain | Den | General | 0 | June 30th 03 07:32 PM |
newb questions about SCSI hard drives | fred.do | General | 7 | June 26th 03 01:59 AM |