If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Sigh - Not another Motherboard Replacement. Strange Boot issues.
Weird things going on here and haven't found much to help me:
System is P4 2GHz on an Asus P4P800 running XP SP1, latest updates. Two hard drives on Primary IDE Channel; Plextor CD writer on Secondary IDE Channel, and 2 HD's on an IDE ATA/133 PCI controller card. The PROBLEM 1. Recently, boot-up started to get slow: each stage of the boot process caused an audible click from the Primary Master; 2. Sometimes get a message: MBR error during boot up, which seems to be ignored and boot up proceeds; 3. Sometimes get "Disk: unable to find NTLDR error, but not often; 4. Event Viewer reports: The driver detected a controller error on \Device\Harddisk 1 (or 3) [Primary Master and Slave]. And: ATAPI: The device, \Device\Ide\IdePort0, is not ready for access yet; 5. SMART and manufacturer's disk utility failed to find problems either with Disk 03 (Primary Slave) or Disk 01 (Primary Master; Windows chkdsk reported no problems either. Also ran up-to-date anti-virus program (AVG Pro) without finding any problems. Swapped out IDE Cable - same problems. 6. Bought Acronis True Image 7.0 (www.acronis.com) in anticipation of a HD failure and used it. (BTW, as an aside - this program is absolutely first class, and has a really intuitive interface: and unlike many utilities like Norton Ghost, which has to operate in PC DOS, True Image 7.0 permits fast, full disk image backups on the fly while still using Windows, and it creates the image in a secure area which can't be touched by Windows or viruses. It also allows scheduled incremental backups while still in Windows. To say I'm impressed by this program $38-48 would be an understatement - see below); 7. Replaced Primary Master drive with a new 120 Gb Western Digital yesterday and restored the backup of C:\ (40Gb) I did using Acronis True Image to my new HD in 40 minutes flat! All was well till I restarted, when the same problems which caused me to replace the HD started to recur - intermittently, eg MBR error 3 and the NTLDR issue. Rebooting several times until the BIOS recognises all the Drives usually solves the problems though, and everything runs OK - like now; 8. Updated my BIOS a few hours ago. Same problems. I'm really beginning to think this is a mobo ATA controller issue. Any ideas greatly appreciated. Anthony |
#2
|
|||
|
|||
Anthony PDC wrote:
Weird things going on here and haven't found much to help me: 8. Updated my BIOS a few hours ago. Same problems. I'm really beginning to think this is a mobo ATA controller issue. I was having weirdo boot problems with my p4p800, I'd get bios checksum failures, drives not found etc. Then the next try it would boot right up. I started to suspect a PSU but the voltage checked OK. Still I had a feeling the PSU might be the problem and got a Sparkle 350W PSU (the one in the machine was some no-name-I'd-ever-heard-of brand) and it's been running perfect since. Someone last week posted they had one acting flakey on 2 PSU's they had (A 400W and a 520W) but ran fine on another 300W PSU. I think these boards are VERY sensitive to one of the voltages and if it's off, all sorts of flakey stuff happens. Just what I found ad have noticed from other posters. -- Stacey |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help: Determining motherboard form factor | Darren Harris | General | 3 | July 2nd 04 02:26 AM |
what's the best motherboard for amd athlon 64 | Mike Henley | Homebuilt PC's | 2 | April 20th 04 08:33 PM |
Can my Motherboard make a Router Disapear? | Tintax | Homebuilt PC's | 13 | August 25th 03 10:19 PM |
W2000 motherboard switch? | Michael Volow | Homebuilt PC's | 1 | July 8th 03 08:02 PM |
motherboard died and was wondering if this will work | kony | General | 0 | June 30th 03 04:08 AM |