If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
CPU Temp Hitting 80C!!!!
Hi
I've got a A7N8X Deluxe, Athlon XP 2600, 512 PC2700 and the processor seems to be at a really high temp. When I start the PC, it's about 50C and the mobo about 25 - 30C (according to both Asus Probe and the bios). When I start using it, e.g. gaming, things go crazy and the PC starts beeping, the temps in the 70C - 80C region!! I restarted after the temp got high and the "speaking lady" at POST said "CPU fan failed" although everything was working. When I went into the bios, every 2 seconds, the CPU temp would go from 30C to 60C and back and forth. What's going on?! All connections seem fine, fans working, I've even flashed the latest bios in again. Please help!! Thanks Munaj |
#2
|
|||
|
|||
"Munaj Choudhury" wrote in message
... Hi I've got a A7N8X Deluxe, Athlon XP 2600, 512 PC2700 and the processor seems to be at a really high temp. When I start the PC, it's about 50C and the mobo about 25 - 30C (according to both Asus Probe and the bios). When I start using it, e.g. gaming, things go crazy and the PC starts beeping, the temps in the 70C - 80C region!! I restarted after the temp got high and the "speaking lady" at POST said "CPU fan failed" although everything was working. When I went into the bios, every 2 seconds, the CPU temp would go from 30C to 60C and back and forth. What's going on?! All connections seem fine, fans working, I've even flashed the latest bios in again. Please help!! That's what you get for buying AMD. Didn't you hear that these CPUs actually MELT? |
#3
|
|||
|
|||
In article , "Munaj
Choudhury" wrote: Hi I've got a A7N8X Deluxe, Athlon XP 2600, 512 PC2700 and the processor seems to be at a really high temp. When I start the PC, it's about 50C and the mobo about 25 - 30C (according to both Asus Probe and the bios). When I start using it, e.g. gaming, things go crazy and the PC starts beeping, the temps in the 70C - 80C region!! I restarted after the temp got high and the "speaking lady" at POST said "CPU fan failed" although everything was working. When I went into the bios, every 2 seconds, the CPU temp would go from 30C to 60C and back and forth. What's going on?! All connections seem fine, fans working, I've even flashed the latest bios in again. Please help!! Thanks Munaj Overclocked ? Overvolted core ? Improperly installed HSF/no grease or thermal interface material ? Extra standoffs underneath motherboard, shorting to power planes ? I'd try reinstalling the HSF, taking care to ensure the contact patch on the heatsink, lines up with the die. I think it is possible to rotate some HSF 180 degrees and mess that up. HTH, Paul |
#4
|
|||
|
|||
On Wed, 18 Feb 2004 15:51:00 +1100, "Darkfalz"
wrote: That's what you get for buying AMD. Didn't you hear that these CPUs actually MELT? Moron. -- Andrew. To email unscramble & remove spamtrap. Help make Usenet a better place: English is read downwards, please don't top post. Trim messages to quote only relevent text. Check groups.google.com before asking a question. |
#5
|
|||
|
|||
If your getting the fan failure warning then the fan is probably spinning
too slowly...what rpm is it reading? If the fan and heatsink are all choked up with dust clean it out. -- *****Replace 'NOSPAM' with 'btinternet' in the reply address***** "Munaj Choudhury" wrote in message ... Hi I've got a A7N8X Deluxe, Athlon XP 2600, 512 PC2700 and the processor seems to be at a really high temp. When I start the PC, it's about 50C and the mobo about 25 - 30C (according to both Asus Probe and the bios). When I start using it, e.g. gaming, things go crazy and the PC starts beeping, the temps in the 70C - 80C region!! I restarted after the temp got high and the "speaking lady" at POST said "CPU fan failed" although everything was working. When I went into the bios, every 2 seconds, the CPU temp would go from 30C to 60C and back and forth. What's going on?! All connections seem fine, fans working, I've even flashed the latest bios in again. Please help!! Thanks Munaj |
#6
|
|||
|
|||
My 2400XP sits idle at around 36 degrees and goes to 50 when really going
for it.Check ur heatsink is actually mounted correctly on the die of the chip.This is best done when the motherboard is taken out of the case.Also use compound like `Arctic Silver` to get a good contact between the two.Clean both the bottom of the heatsink and the die of the chip with some good cleaning agent to get rid of all excess deposits before applying new compound. |
#7
|
|||
|
|||
66C is too hot.
-- *****Replace 'NOSPAM' with 'btinternet' in the reply address***** "KB" wrote in message ... My XP2800 gets up to 52c unloaded and around 66 loaded. No probs with HSF, no problems with Thermal compound. Faster fan on HS then lower temps, slower fan then high temps. |
#8
|
|||
|
|||
"66C is too hot"
Like I said, no problem with HSF, no problem with Thermal compound. Very thin layer on clean die and heatsink. There are others who have their 2800's getting up to 66c under load. If I had the 4500rpm fan that I used to(Coolermaster HAC-81) then max cpu temp under load was and would be a lot less than 66c. Reason one for not having it still: too much noise and vibration. Reason two for present HSF: hours of too much noise. If room temp is low then cpu temp drops if high the cpu temp high. Front fan makes no diff, clean hs base and die, re apply compound, no difference. Go back to old compound(normal silicon based), lower cpu temps. |
#9
|
|||
|
|||
Have you got a rear exhaust fan in your case?
maybe you just need to invest is a better quality heatsink...I like the Thermalright SLK800 / 900, they can be quiet if you select the right fan. I'm running an XP2600+ @ 2595MHz with 2.1V and it never goes over 48C full load...at default settings it's around 38C full load. -- *****Replace 'NOSPAM' with 'btinternet' in the reply address***** "KB" wrote in message ... "66C is too hot" Like I said, no problem with HSF, no problem with Thermal compound. Very thin layer on clean die and heatsink. There are others who have their 2800's getting up to 66c under load. If I had the 4500rpm fan that I used to(Coolermaster HAC-81) then max cpu temp under load was and would be a lot less than 66c. Reason one for not having it still: too much noise and vibration. Reason two for present HSF: hours of too much noise. If room temp is low then cpu temp drops if high the cpu temp high. Front fan makes no diff, clean hs base and die, re apply compound, no difference. Go back to old compound(normal silicon based), lower cpu temps. |
#10
|
|||
|
|||
"KB" wrote in message ... "66C is too hot" Like I said, no problem with HSF, no problem with Thermal compound. Very thin layer on clean die and heatsink. There are others who have their 2800's getting up to 66c under load. If I had the 4500rpm fan that I used to(Coolermaster HAC-81) then max cpu temp under load was and would be a lot less than 66c. Reason one for not having it still: too much noise and vibration. Reason two for present HSF: hours of too much noise. If room temp is low then cpu temp drops if high the cpu temp high. Front fan makes no diff, clean hs base and die, re apply compound, no difference. Go back to old compound(normal silicon based), lower cpu temps. Check the VCore in the bios and set to 1.65, sometimes at the default setting it will be 1.7 or 1.75 and this will make the CPU run hotter. My 2500 + jumped upto 75oC when I installed a new vid card which blocked air flows, reducing VCore dropped temp down to 50oC. Andy -----= Posted via Newsfeeds.Com, Uncensored Usenet News =----- http://www.newsfeeds.com - The #1 Newsgroup Service in the World! -----== Over 100,000 Newsgroups - 19 Different Servers! =----- |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A7N8X Motherboard Low Temperature Sensitivity, CMOS Checksum Error | kony | General | 6 | October 18th 04 05:38 AM |
temp? | Toshi1873 | Homebuilt PC's | 1 | April 9th 04 11:18 PM |
CPU cooler and temp information stuff (kind of long) | Roger M | Overclocking AMD Processors | 1 | March 8th 04 11:20 AM |
Confused over AMD PR rating | Overclocking AMD Processors | 2 | January 28th 04 01:18 AM | |
GA 7N400-PRO...new bios | NewB | Overclocking AMD Processors | 5 | August 19th 03 09:06 AM |