If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
power supply questions
Hi,
I work at a night club and we have a lighting control board that has two mother boards. The other day it wouldn't try to come on at all, acting like it wasn't getting power. So I made sure it was getting power, unplugged and plugged it back several times, and tried starting it several times. Finally after a number of attempts it started up and ran fine, but a couple of tech people said it sounds like the power supply is going bad. It has a HIGH POWER® HPC-360-302 DF power supply. If I remember right it has five connectors: 1 twenty wire, 3 four wire, and 1 two wire. We tried replacing it with a newer type from Micro Center, and had to use an adapter to try to make the two wire connector work. It looked like everything connected right but it never would boot up with that power supply, and said it needed us to insert a system disc or something. When I put the old power supply back in it started up fine again. Can anyone let me know what happened, and suggest what to do if we can't get another power supply just like the one that's going bad? I'm afraid it has been discontinued. Thanks for any help! David |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Power Supply Questions | Mike Azzopardi | Homebuilt PC's | 8 | January 2nd 07 05:41 AM |
Power Supply Questions | Joe | Homebuilt PC's | 2 | November 24th 05 01:33 AM |
Power Supply Questions | LuckyDog | Homebuilt PC's | 19 | November 22nd 05 09:31 PM |
Power Supply Questions | [email protected] | Homebuilt PC's | 9 | April 28th 05 06:13 PM |
Power Supply questions | No Data Sent | Overclocking AMD Processors | 2 | July 4th 03 12:08 AM |