A7V333, Athlon XP2600+, KVR333, XFX Geforce Ti4200

Thanks, I'll try that.

"Paul" wrote in message
...
Did you happen to change the JP1 or JP2 jumpers? These are the so-called
undocumented memory voltage jumpers. I recall some people on this NG
stating
that they had problems when the went to faster CPU while the jumpers where
in a
configuration that muskin??? recommended to keep the memory operating
inside the
designed tolerances. After returning to default positions, they indicated
system began operating normally.

LOL
Paul

"M Van Ert" wrote in message
a...
It is a 333FSB - not sure of vcore setting (set for auto), board not
here,
the external frequency set at 133 - tried 166 & it wouldn't boot at all.
The
2.5 refers to SDRam CAS latency setting. The bios shows XP2600 alright,
just
won't boot. I first had installed DDR 2100 266 ram and setup on auto, it
would boot fine into XP Home but would freeze within 10 or 15 minutes,
much
sooner if I tried a game such as one based on Tom Clancy's stuff when it
would freeze within a minute of entering the game. That's when I changed
to
the KVR333 ram.

"Paul" wrote in message
...
What revision of the board do you have? Also is it a 333 FSB or 266
FSB
CPU--sounds like a 333 from your post?

I seem to remember reading that the earlier version boards may be
missing
some
signal lines that come from the CPU to allow for auto selection.

Is Vcore set to proper voltage?


BTW...was that a ? I think you meant 12.5..right?


"M Van Ert" wrote in message
a...
I have this combination & I can't get past initial boot segment.
Won't
boot at
all configured on auto. Manually set @ 133 CPU MHz @ 2.5 -
Suggestions
please!