If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Piotr Makley wrote:
I am in the UK and was wondering if there was any merit in cleaning the brass pins of my three-pin mains plugs. In many cases the pins look tarnished and I must have had some of these plugs for 10 or 20 years. The plugs all seem to work well and they do not heat up. But I thought it would be good practise to sandpaper the pins so they were shiny. Am I wasting my time? Is this for real???? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
HP Deskjet 1220 Cleaning Kit problem | Matti Partonen | Printers | 5 | November 11th 04 01:04 AM |
DAT drive recommendations? | Jonathan Sachs | Storage (alternative) | 34 | October 14th 04 01:44 PM |
USB Pins...again | Howard | Gigabyte Motherboards | 0 | October 27th 03 04:54 PM |
Dial up modem problem | Richard Freeman | Homebuilt PC's | 21 | September 22nd 03 05:50 AM |
Vuescan, IR cleaning, which film scanner? | Sanaka | Scanners | 1 | August 21st 03 04:24 PM |