If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
GA-K8NXP-SLI and 3D1 plus 160GB Seagate SATA
Hi
Just purchased parts for my new PC,including the following parts: GA-K8NXP-SLI and 3D1 160GB Seagate SATA Initially I will be using the single 160GB drive and connecting it to the nvidia SATA connection, but this leads me to the following questions: 1. Will WinXP SP2 setup see this disk on this controller without additional drivers? 2. I also plan to add a second 160GB HD sometime in the future and configure as RAID 1 (mirror). For this to be successful how do I go about setting up the first drive now, do I need to set it up as RAID drive in anyway (even though its only a single drive by itself). Sorry if this sounds a bit confusing, all this SATA and RAID technology is still very new to me. Regards Adrian |
Thread Tools | |
Display Modes | |
|
|