If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
2 beeps (parity error) on boot-up w/ USB keyboard...
Dave... thanks..
That is exactly how I ended up configuring it after Ari & Pen's replies.. No more parity errors. thanks to all -d "Dave" wrote in message ... +5V D- D+ Gnd Not Connected | | | | | * * * * * * * * * | | | | +5V D- D+ Gnd The +5V may also be called VCC |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can't boot from CD | Zotin Khuma | General | 6 | November 16th 04 10:18 PM |
Most Likely Cause Of No Beeps At Start of Boot? | [email protected] | General | 1 | September 19th 04 02:39 AM |
Boot problem with Promise SATA Fasttrack S150TX2 Plus | Wizard | General | 0 | September 13th 04 06:54 PM |
Hard drive that boots elsewhere refuses to boot in this machine | Simon O'Connor | General | 9 | July 22nd 03 06:34 AM |
Dual Boot, How? | Paul \(Erie\) | General | 1 | June 24th 03 04:36 PM |