A computer components & hardware forum. HardwareBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » HardwareBanter forum » General Hardware & Peripherals » General
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

bit scared....



 
 
Thread Tools Display Modes
  #1  
Old March 2nd 05, 12:16 PM
Rex Mundi
external usenet poster
 
Posts: n/a
Default bit scared....

Hi all,

I have just brought pretty much a new system which includes:

Asus A7N8X-E Deluxe.
Antec Truepower 480w PSU
1gb Coursair Value Select Ram
9600XT Radeon

I wired it all up last night, went to switch it on and the PSU blew
with a cloud of smoke, fearing the worst i used an old Qtec Psu i had
laying around to test everything worked....

However, when i switch my machine on, it freezes at the Bios boot
screen, around the time of the RAM check and recognisind the hard
drives. It varies from time to time.

This leads me to think that all is not lost, as the motherboard powers
on and starts it process, the ram seems ok as i tried with some other
Ram with still the same results.

Does anyone know of a problem that could cause this, or do you think
that some is fried in my system?

Thanks

Rex (a concerned user... :-s )

  #2  
Old March 2nd 05, 01:21 PM
CK
external usenet poster
 
Posts: n/a
Default

Have you tried different RAM Chips , may be possible that one of them was
affected when the PSU blew

--
Kind Regards

www.networkingbasics.co.uk
www.ckconsultants.co.uk
"Rex Mundi" wrote in message
...
Hi all,

I have just brought pretty much a new system which includes:

Asus A7N8X-E Deluxe.
Antec Truepower 480w PSU
1gb Coursair Value Select Ram
9600XT Radeon

I wired it all up last night, went to switch it on and the PSU blew
with a cloud of smoke, fearing the worst i used an old Qtec Psu i had
laying around to test everything worked....

However, when i switch my machine on, it freezes at the Bios boot
screen, around the time of the RAM check and recognisind the hard
drives. It varies from time to time.

This leads me to think that all is not lost, as the motherboard powers
on and starts it process, the ram seems ok as i tried with some other
Ram with still the same results.

Does anyone know of a problem that could cause this, or do you think
that some is fried in my system?

Thanks

Rex (a concerned user... :-s )



  #3  
Old March 3rd 05, 05:48 AM
CK
external usenet poster
 
Posts: n/a
Default

Have you tried different RAM Chips , may be possible that one of them was
affected when the PSU blew

That's what he said. Not that I can come up with anything more
constructive, but he did say that he'd tried that...

CK
  #4  
Old March 3rd 05, 02:32 PM
kony
external usenet poster
 
Posts: n/a
Default

On 2 Mar 2005 07:16:32 -0500,
lid (Rex Mundi)
wrote:

Hi all,

I have just brought pretty much a new system which includes:

Asus A7N8X-E Deluxe.
Antec Truepower 480w PSU
1gb Coursair Value Select Ram
9600XT Radeon

I wired it all up last night, went to switch it on and the PSU blew
with a cloud of smoke, fearing the worst i used an old Qtec Psu i had
laying around to test everything worked....


So the PSU was brand new, that is, had never been turned on
by you before? I'm wondering if it was just a
manufacturer's defect or you had it set to wrong voltage?

Regardless, an "old Qtec" may not be so useful, as it might
easily be insufficient capacity for the system. In fact I
would assume it was insufficient and recommend replacing it
even if it had worked.


However, when i switch my machine on, it freezes at the Bios boot
screen, around the time of the RAM check and recognisind the hard
drives. It varies from time to time.


Clear CMOS. Try booting without changing any bios settings.
Strip system down to minimal components. Remove all but 1
memory module, unplug drives, etc, and see if it'll boot to
a DOS floppy.


This leads me to think that all is not lost, as the motherboard powers
on and starts it process, the ram seems ok as i tried with some other
Ram with still the same results.


If it'll boot to DOS, then make a memtest86 boot floppy on
another system and run that to test memory.



Does anyone know of a problem that could cause this, or do you think
that some is fried in my system?


Only video card, 1 memory module, CPU and heatsink/fan is
needed to post the system. Attach a keyboard to get into
bios and check the health monitor screen. Note temperature,
voltage. Take this a step at a time starting out with a
simplest bare configuration and adding back parts one at a
time.
 




Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Scared to death with A7V8X-X!!!!! cimetière Overclocking AMD Processors 11 July 25th 04 01:54 AM
Scared to death with A7V8X-X!!!!! cimetière Asus Motherboards 5 July 16th 04 10:51 AM
I removed my Northbridge...and now i'm scared Richard Dower Homebuilt PC's 0 May 26th 04 01:01 AM
Need URGENT cooling advice!! I'm too scared to do anything much! Perdita X. Dream General 11 October 25th 03 04:49 AM
Is Duron 1.3GHz Compatible with KT7 (non Raid) m'board....I'm scared..... Strontium Homebuilt PC's 0 August 15th 03 07:30 PM


All times are GMT +1. The time now is 06:49 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 HardwareBanter.
The comments are property of their posters.