If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
RAID 0 setup questions
I have a pair of WD 200GB 8MB cashe drives that i am trying to set up
in my system. The motherboard is a chaintech 7NJS Ultra with an onboard promise FastTrack 376 RAID controller. The manual (for the mainboard) is translated English, and not that much help. My question is jumper settings. I read on one site to use both as Master. Is this correct, or should i use another method (Master/Slave, Slave/Slave, Cable Select/Cable Select)? Best is to setup both drives as Master and connect them each on a seperate 80-pins cable to the two RAID connectors. |
#2
|
|||
|
|||
OK, thanks. I will go with the dual Master option.
Now, must i format my HD before i install it onto the RAID card, or after? Thanks again! "Ronald" wrote in message ... I have a pair of WD 200GB 8MB cashe drives that i am trying to set up in my system. The motherboard is a chaintech 7NJS Ultra with an onboard promise FastTrack 376 RAID controller. The manual (for the mainboard) is translated English, and not that much help. My question is jumper settings. I read on one site to use both as Master. Is this correct, or should i use another method (Master/Slave, Slave/Slave, Cable Select/Cable Select)? Best is to setup both drives as Master and connect them each on a seperate 80-pins cable to the two RAID connectors. |
#3
|
|||
|
|||
On Sun, 31 Aug 2003 20:17:13 GMT, "Mt" wrote:
OK, thanks. I will go with the dual Master option. Now, must i format my HD before i install it onto the RAID card, or after? For a fresh installation or usage, (no files already on the drives) you always define the array first, in the raid controller's bios that appears right after POST. After defining the array the drive(s) (array) is partitioned, then formatted. Dave |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help with RAID transfer from MSI to ASUS | ECB | General | 0 | August 23rd 03 06:18 AM |
Optimal IDE setup? | Jim Turner | General | 2 | August 16th 03 01:39 AM |
Raid notification after market program | Robert J. Stevens | General | 0 | August 9th 03 01:56 AM |
Exceed mobo maximum HD size with RAID? | kony | General | 1 | July 21st 03 05:32 AM |
help. ga-7vrxp raid trouble, compatability and warning | todd elliott | General | 0 | July 17th 03 06:50 PM |