|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 19th 08, 07:33 PM
posted to comp.sys.intel
|
|||
|
|||
Motherboard DG33 for Core2Quad Q6600 : Power Consumption question
Hi,
I have this motherboard installed with 2 GB RAM, a 250 GB Seagate Baracuda hard disk and LG DVD RW drive. My power-supply says its 450W. My UPS has a rating of 650 VA (should be around 350 watts). My display is also plugged into the UPS, which is a LG flatron 19" TFT. My UPS is not able to support my system during a power fluctuation. my question is, how do I measure as to how much is my system using from the mains ? That seems to be the only way I could decide on my power usage and then only I can choose the right UPS configuration for my system. Please suggest... regards raghav.. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mATX motherboard for Core 2 Quad Q6600 | Bob Fleischer | Homebuilt PC's | 1 | March 3rd 08 02:43 PM |
| power consumption question | Pavel Ferenc | General | 3 | February 24th 06 07:58 PM |
| C'T magazine article - motherboard power consumption | larrymoencurly | General | 3 | June 30th 03 09:44 AM |
| C'T magazine article - motherboard power consumption | larrymoencurly | Homebuilt PC's | 5 | June 30th 03 09:44 AM |
| C'T magazine article - motherboard power consumption | larrymoencurly | General | 3 | June 30th 03 09:44 AM |
Linear Mode
