If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
PTZ programming
Hello Sir,
I would like to program the PTZ camera which is daynapel D86 series. I successfully control the PTZ camera with Pan left/right, tilt up/ down, zoom in/out with pelco protocol. But I cant understand the acknowlegement data from PTZ. I would like to interpret acknowledgement data from PTZ. I haven't understand protocol for acknowledge data from PTZ. Could anybody help me in this regard to understand what PTZ acknowledge? what is acknowledge data tells us? Thanks in advance for your commnets. Regards, Naresh |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Help programming IXA& IXP | Férrer | Intel | 5 | November 6th 05 03:04 PM |
Programming Notepad | Ivan Kobrinsky | General Hardware | 0 | March 3rd 05 06:05 PM |
CD ROM control programming, | Shin | General Hardware | 0 | September 6th 04 09:19 PM |
Programming Hardware | Erhan | General | 0 | September 20th 03 11:11 PM |
Regarding programming RS-485 | Manikandan | Intel | 0 | July 25th 03 12:06 PM |