If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Replicing the Controller of Fujitsu Eternus 3000 Model 50 ....
Hi.everyone...
Fujitsu Eternus 3000 Model 50 is running in our company. two controller units are installed. One controller unit is failed. I purchased new controller unit but don't know how to replace the controller unit 1) It's possible that the controller unit is replaced in online ? 2) After replacement, configuration synchronizaion between new controller and existing controller is started automatically ? Please let me know how to replace the controller unit.... Thank you. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Proliant 3000 300/333MHz model | Jason Arthurs | Compaq Servers | 7 | August 11th 05 04:32 PM |
3000 vs. 4700 model for gaming | jim | Dell Computers | 12 | November 29th 04 10:46 PM |
Why 2200+ & 2800+ in both model 8 & model 10 Sempron? | Michael Brown | General | 2 | September 27th 04 05:40 AM |
Why 2200+ & 2800+ in both model 8 & model 10 Sempron? | [email protected] | Homebuilt PC's | 0 | September 14th 04 12:46 AM |
Why 2200+ & 2800+ in both model 8 & model 10 Sempron? | [email protected] | General | 0 | September 14th 04 12:46 AM |