If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Compaq Deskpro 2000
I am tryin to overclock this thing. There is something wrong with the
BIOS on it. Everytime i try to get into the BIOS it comes up with an error message about the keyboard not bieng supported. I can see any jumpers on it but i would expect the multiplier to be unlocked as it i quite old. Processor: Pentium pro with MMX @ 200mhz RAM: 128MB HDD: 3GB MotherBoard: Compaq 237716-002 PLL: 9169cf-46 Does anyone know a Pin Mod for it and where to find the jumpers on the thing. |
#2
|
|||
|
|||
Compaq Deskpro 2000
'naza' wrote, in part: I am tryin to overclock this thing. There is something wrong with the BIOS on it. Everytime i try to get into the BIOS it comes up with an error message about the keyboard not bieng supported. I can see any jumpers on it but i would expect the multiplier to be unlocked as it i quite old. Processor: Pentium pro with MMX @ 200mhz _____ It is extremely unlikely that any overclocking settings will be in the Compaq BIOS. Since the highest clock speed for the Pentium Pro was 200 MHz, and since the Pentium Pro was not supported by Pentium MMX Motherboards, it is unlikely that any jumpers for a multiplier greater than 3.5 exists. That leaves raising the FSB as the only way to overclock. Raising the FSB and core voltage with a Compaq Pentium Pro motherboard is not going to be possible without modifications, and may be impossible in any case: the Pentium Pro 200 MHz was at the top of the speed range and core voltage range of the Pentium Pro series, and a Compaq may just not have a margin to increase either value. Also, the Pentium Pro did not have the MMX instruction set. Phil Weldon "naza" wrote in message oups.com... I am tryin to overclock this thing. There is something wrong with the BIOS on it. Everytime i try to get into the BIOS it comes up with an error message about the keyboard not bieng supported. I can see any jumpers on it but i would expect the multiplier to be unlocked as it i quite old. Processor: Pentium pro with MMX @ 200mhz RAM: 128MB HDD: 3GB MotherBoard: Compaq 237716-002 PLL: 9169cf-46 Does anyone know a Pin Mod for it and where to find the jumpers on the thing. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Compaq FAQ | HH | Compaq Computers | 1 | September 11th 06 09:54 PM |
upgrade for compaq presario 5834 | bozomedic | Compaq Computers | 0 | December 27th 05 09:31 PM |
FS PRINTER PARTS trays fusers drums printheads -- oki fujitsu hp genicom epson ibm dec jetdirect laserjet lexnmark qms okidata ml320 mannesmann tally printonix tektronix qms toshiba zebra otc ibm lexmark intermec dec compaq montreal canada toronto o | [email protected] | Printers | 1 | March 15th 05 06:50 AM |
Compaq Deskpro 2000 - Need help identifying model # | Tragik Magik | Compaq Computers | 6 | September 9th 04 08:01 AM |
Compaq user diagnostics diskette | bananaboat | Compaq Computers | 3 | April 21st 04 03:05 AM |