|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 30th 09, 01:27 AM
posted to alt.sys.pc-clone.compaq,comp.sys.hp.hardware
|
|||
|
|||
CMOS bad ? factory default settings
For compaq PC's, I found this note I wrote in an old Service QRG ( from
2001): 1. Hold Fn key and power up. 2. Tap Fn+F11 quickly 3. mem counts up 4. disk seeks 5. Then get " Error 162" ( this normal) 6. Press F1 to "Save Changes" - now back to factory default settings Might still work on current pc's ?? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Restore to factory settings | [email protected] | Dell Computers | 1 | December 11th 08 10:09 PM |
| Gateway500 factory Settings | Hicksey | Gateway Computers | 8 | July 23rd 06 05:08 AM |
| HP 3600n resetting to factory settings? | Mirko | Printers | 6 | March 5th 06 11:24 AM |
| how to test psu and reset to cmos to default | Tanya | General | 23 | February 7th 05 09:56 AM |
| Netapp factory settings | Paul | Storage & Hardrives | 4 | February 29th 04 10:48 AM |
Threaded Mode