If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
HP CDRW says Calibration area full
I get error message while trying to burn anything with report that the
"Calibration area is full". This is an old HP 7200 that has not seen many burns or much use. Has anyone had a problem like this and know how to go about fixing? I tried in other computer but same results. I have replaced this drive but don't want to trash it if it is s simple fix. Thanks Proto |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
my new mobo o/c's great | rockerrock | Overclocking AMD Processors | 9 | June 30th 04 08:17 PM |
Power Calibration error - need new power supply | Anonymous | Homebuilt PC's | 24 | May 10th 04 08:03 PM |
CDRW not being detected as pri or sec slave... | Fredericks | Homebuilt PC's | 3 | April 21st 04 04:52 AM |
CDRW not being detected as pri or sec slave... | Fredericks | General | 2 | April 18th 04 10:01 PM |
My next CDRW High Speed problem | doug | Cdr | 5 | July 29th 03 07:55 PM |