Angry about samsung CLX 3175FN printer

Hello,

I have a samsung CLX 3175FN printer since 2 years. It worked fine until
now: the printer gives this message: "Error sytem cycle power".

I do beleive that I'm not the only one with this problem because there's
a lot of users asking for responses to this specific problem. It seems
to be the fuser but it's not sure.

Now this printer isn't sold anymore. I baught it because I thought it
was cheaper than a inkjet printer in the long term... But now I have a
broken expensive printer with 4 new toners... Shame on Sammsung... Arg...

Sylvain

Disconnect all power for about 5 minutes and try again, if this doesn't
cure the problem 'it could be' the fuser as you say.

The fuser normally is a special lamp inside a roller the produces heat
to melt the toner, here's a clip 'of the 3185 model.'
(http://www.youtube.com/watch?v=QfaRbdlHz6c)

davy

Hello,

Thank you for the tips but I did the first one last week.
Has 'it could be the fuser' I'm not going to change it because it's
expensive (70 €) and because it's not sure that the problem comes from
this spare part.

My printer is ONLY TWO YEARS OLD... and I'm not the only one to have
this problem so soon. This printer is simply fragile... expensive but
fragile...

Never Samsung again...

Sylvain

Le 02/11/2012 22:37, davy a écrit :
Disconnect all power for about 5 minutes and try again, if this doesn't
cure the problem 'it could be' the fuser as you say.

The fuser normally is a special lamp inside a roller the produces heat
to melt the toner, here's a clip 'of the 3185 model.'
(http://www.youtube.com/watch?v=QfaRbdlHz6c)

davy