If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Line In - No Sound!! H E L P !!!
Hi
i mess about from time to time doing a bit of home music recording. when i went to do some recently i found that i'm not getting any signal through my line in ! i tried the mic in too and still nothing!! i've re-installed drivers. i've tried different leads etc. i've checked the mixer input is set to line-in. i've physically removed the card and put it back in. i haven't installed any new audio software or hardware recently to conflict with it. if i play a song in media player and use the 'creative recorder' it WILL record the song live as it plays. if i try this with soundforge then it doesn't record anything. but always NOTHING thru the line-in!!!! i'm running a dell dimension 8250, Pentium 4 2.4ghz, 256 ram, windows xp home edition service pack 1. the card is just the basic OEM without the breakout box etc etc. it used to work fine apart from the usual bit of latency!! any help would be GREATLY appreciated!!!!! thanks in advance chj |
#2
|
|||
|
|||
i've re-installed drivers. i've tried different leads etc. i've checked the mixer input is set to line-in. i've physically removed the card and put it back in. This is a "duh" kind of question, but you haven't accidentally managed to mute the input(s) in the control panel by any chance, maybe by running some program that fiddled with these settings without asking you (it happens from time to time; why? It's windows... ). You'll need to go to the Properties window and switch over to recording mode to make sure all inputs are really enabled. If this does not solve your problem, go to soundforge's website and check the faq, and then email their tech support before contacting creative, because from what I hear they're hopeless and should only be tried as a desperate last-ditch attempt. |
#3
|
|||
|
|||
I have the same problem. I haven't been able to figure it out either.
Lee "Nimrod K Funk" wrote in message ... Hi i mess about from time to time doing a bit of home music recording. when i went to do some recently i found that i'm not getting any signal through my line in ! i tried the mic in too and still nothing!! i've re-installed drivers. i've tried different leads etc. i've checked the mixer input is set to line-in. i've physically removed the card and put it back in. i haven't installed any new audio software or hardware recently to conflict with it. if i play a song in media player and use the 'creative recorder' it WILL record the song live as it plays. if i try this with soundforge then it doesn't record anything. but always NOTHING thru the line-in!!!! i'm running a dell dimension 8250, Pentium 4 2.4ghz, 256 ram, windows xp home edition service pack 1. the card is just the basic OEM without the breakout box etc etc. it used to work fine apart from the usual bit of latency!! any help would be GREATLY appreciated!!!!! thanks in advance chj |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
writing cd`s | biggmark | Cdr | 7 | December 31st 04 08:57 AM |
Is My Burner Broken? | ggroups2 | General | 3 | August 12th 04 03:54 AM |
Could not perform fixation? | Princess Morgiah | Cdr | 8 | June 27th 04 02:30 AM |
Nero help needed | foghat | Cdr | 0 | May 31st 04 08:23 PM |
dBA and Bels | Rod Speed | Storage (alternative) | 26 | December 29th 03 09:43 AM |