|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#31
July 27th 06, 05:23 PM
posted to alt.sys.pc-clone.gateway2000
|
|||
|
|||
T2865 EMAchine Starts by itself
If you are lucky enough to have an Intel-designed motherboard, you can get the
beep codes by downloading the spec for the motherboard from the Intel web site. To my surprise, eMachines uses some Intel boards... Ben Myers Thanks Ben, I figured you would have a good suggestion, thanks ! I should have thought of looking for the motherboard manual/specs. The T2865 has a FIC AU31 (AMD CPU) and is a pretty common/cheap part. http://www.fic.com.tw/product/mother.../k7m-nf18g.jpg Best Regards, Bob Johnson 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| eMachine power supply issue | nancy13g | Gateway Computers | 2 | March 12th 06 03:54 AM |
| eMachine power supply issue | kony | Gateway Computers | 0 | February 4th 06 11:50 AM |
| eMachine power supply issue | Ben Myers | Gateway Computers | 0 | February 4th 06 02:28 AM |
| eMachine power supply issue | M | Gateway Computers | 0 | February 4th 06 01:37 AM |
| Axis 2100 starts flickering at dawn | Martin Meyer | Webcams | 4 | June 25th 04 04:40 AM |
Linear Mode
