If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Opening a Compaq base unit
I have a Compaq EN series 6400 computer. I am wanting to install a new
CDRW drive but I cannot figure out how to open the case. There are two crescent shape buttons either side of the front panel but they don't seem to do anything and I can't see any screws which would release the cover. If anybody has any possible ideas, I'd be very grateful, Thanks, Peter. |
#2
|
|||
|
|||
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
pc problems after g card upgrade + sp2 | ben reed | Homebuilt PC's | 9 | November 30th 04 01:04 AM |
Compaq FAQ | HH | Compaq Computers | 0 | October 17th 04 12:49 PM |
Compaq FAQ | HH | Compaq Computers | 0 | July 31st 04 02:23 PM |
Compaq user diagnostics diskette | bananaboat | Compaq Computers | 3 | April 21st 04 03:05 AM |
Compaq ready to go | Jazzy Ban | Compaq Computers | 0 | October 14th 03 02:54 PM |