"Non-Warranted" Drive

Replacing a defunct drive in a Netfinity 5000 on an IBM 4M controller.
Replacement drive is exactly the same model, although not rebranded by
IBM (from Seagate OEM). After ServerRAID Manager rebuilt the drive, it
said the drive was a "non-warranted physical drive" and refused to
recognize it. Any ideas as to why this might be happening and what can
be done about it?

"RichLich" wrote in message
om...
Replacing a defunct drive in a Netfinity 5000 on an IBM 4M controller.
Replacement drive is exactly the same model, although not rebranded by
IBM (from Seagate OEM). After ServerRAID Manager rebuilt the drive, it
said the drive was a "non-warranted physical drive" and refused to
recognize it. Any ideas as to why this might be happening and what can
be done about it?

The seagete drives are not installed with IBM´s firmware, but "non-warranted
physical drive" does not allways mean it doesn´t work, but it is not
supported (or warrented) by IBM.

I have had several server running with these "non-warranted" disks without
problems, but I have also had som problem with arrays unable to rebuild
failed drives, or gennerating SCSI time outs.


Best regards

Johnny

Previously Johnson_dk wrote:

"RichLich" wrote in message
om...
Replacing a defunct drive in a Netfinity 5000 on an IBM 4M controller.
Replacement drive is exactly the same model, although not rebranded by
IBM (from Seagate OEM). After ServerRAID Manager rebuilt the drive, it
said the drive was a "non-warranted physical drive" and refused to
recognize it. Any ideas as to why this might be happening and what can
be done about it?

The seagete drives are not installed with IBM´s firmware, but "non-warranted
physical drive" does not allways mean it doesn´t work, but it is not
supported (or warrented) by IBM.

I have had several server running with these "non-warranted" disks without
problems, but I have also had som problem with arrays unable to rebuild
failed drives, or gennerating SCSI time outs.

Aha. That would be a good reason to switch to a storage solution that
will let you use generic drives and "warrant" them. After all what do
you do if you need a replacement and IBM does not provide the disks
anymore or only at a ridiculous price?

Typical lock-in-hardware. Very bad from a technical point of view.

Arno
--
For email address: lastname AT tik DOT ee DOT ethz DOT ch
GnuPG: ID:1E25338F FP:0C30 5782 9D93 F785 E79C 0296 797F 6B50 1E25 338F
"The more corrupt the state, the more numerous the laws" - Tacitus

Hi,

I have also a problem with this raid controler

a have a raid5 over 4 disks non hotswaps
1 has crashed and i replaced the hard disk with original IBM but
my raid doesn't rebuild
Im not able to manual rebuild the RAID!!!!
any idea's ?

==============
Posted through www.HowToFixComputers.com/bb - free access to hardware troubleshooting newsgroups.