Dual Monitor to TV with NVIDIA graphics card.

I was trying to setup my PC to run a cloned image into my monitor and
onto my t.v. with a rca cable. I am using a NVIDIA GeForce2
GTS/GeForce2 Pro. I was able to set my display to the T.V. by itself,
and the Monitor by itself. My problem is having them both run
simoltaneously. Any Suggestions?
Thank You


P.S. When I had the T.V. running as the monitor the screen was tilted
and not covering the whole screen, any recomendations on maybe a
program that would set up monitor like settings?

wrote on 12 Jan 2006 05:43:55 -0800:

I was trying to setup my PC to run a cloned image into my monitor and
onto my t.v. with a rca cable. I am using a NVIDIA GeForce2
GTS/GeForce2 Pro. I was able to set my display to the T.V. by itself,
and the Monitor by itself. My problem is having them both run
simoltaneously. Any Suggestions?

The GTS doesn't have dual RAMDACs. You need a GF2 MX, GF4 (any) or higher
card.

P.S. When I had the T.V. running as the monitor the screen was tilted
and not covering the whole screen, any recomendations on maybe a
program that would set up monitor like settings?

There should be something in the nvidia settings to adjust overscan and a
few other position settings.

Dan

i looked everywhere and can not find a "monitor" adjustment setting on
my pc. the only one is on my monitor so it doesnt help when running
through my T.V. Anyone with this card, can you tell me where to find
it?
thank you
CJMGUITARIST87

"CJMGuitarist87" wrote in message
oups.com...
i looked everywhere and can not find a "monitor" adjustment setting on
my pc. the only one is on my monitor so it doesnt help when running
through my T.V. Anyone with this card, can you tell me where to find
it?

It is wholly dependent upon the drivers you have installed. If you can post
the version number, someone (maybe me) can tell you where the adjustments
are located.

Dan

it is driver version 3.0.8.2.

it is driver version 3.0.8.2.

It just updated to 4.5.2.3