|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 28th 04, 01:41 AM
|
|||
|
|||
Motherboard ?
Going to be building a new computer soon , does anyone no of any cons to
using a micro atx board over the full atx other than I'd be losing a couple pci slots. Thanks in advance, ST 
|
|
#2
April 28th 04, 03:00 AM
|
|||
|
|||
|
Well the first advantage is that you can stick it in a smaller box.
-- Jan Alter or "ST" wrote in message ... Going to be building a new computer soon , does anyone no of any cons to using a micro atx board over the full atx other than I'd be losing a couple pci slots. Thanks in advance, ST
|
|
#3
April 28th 04, 02:44 PM
|
|||
|
|||
|
On Wed, 28 Apr 2004 00:41:34 GMT, "ST" wrote:
Going to be building a new computer soon , does anyone no of any cons to using a micro atx board over the full atx other than I'd be losing a couple pci slots. Thanks in advance, ST The second serial port (if that interests you), will be on a back slot plate. Of course, if you have the full set of slot holes available, you probably won't use one needed for a PCI card.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Motherboard for P4. | MS | Overclocking | 80 | August 2nd 04 10:14 PM |
| AGP Voltage problem | John | Overclocking | 4 | February 29th 04 10:51 AM |
| I need to replace a bad Asus A7V motherboard | David Cook | General | 1 | October 31st 03 01:40 AM |
| Pentium 4 2.4 temperatures | Lou Pratt | Homebuilt PC's | 6 | August 29th 03 01:17 AM |
| Can my Motherboard make a Router Disapear? | Tintax | Homebuilt PC's | 13 | August 25th 03 10:19 PM |
Linear Mode
